Electrolux EKG5047 ユーザーズマニュアル

 

30 

 

This appliance is designed to be installed with an 
appliance flexible connection only. Supply piping 
should not be less than R

3

/8. Connection is made to 

the Rc ½ (½” B.S.P.) female threaded entry pipe 
located just below the hotplate level on the rear left 
hand side of the appliance. 

Carry out a gas tightness test after 

connecting to the gas supply.  The gas bayonet 
connector must be fitted in the shaded area 
indicated in Fig.2. Take into account that it must be 
possible to pull the appliance forward sufficiently. 

Ensure the hose does not become trapped when 
pushing the appliance into position. 

 

LPG Flexible connections must be a type suitable for 
L.P.G and capable of operation up to 50 mbar and 
carry a red stripe, band or label. 

 

It is recommended that if the appliance is to be 
installed with a flexible supply pipe, a stability 
bracket be fitted and is available from your supplier 
(see Important Safety Requirements).  These 
instructions should be read in conjunction with any 
leaflet packed with the stability bracket. 

 

1.  Place the appliance in its intended position and 

level appliance. 

2.  Mark off 250mm from the left hand side of the 

appliance as shown in dimension 'A', Fig 3a.  
This is the centre line of the fixing bracket. 

3.  Draw a line from the front edge of the feet (see 

Fig.3a) and remove appliance from its position. 
Mark off dimension 'B' (see Fig.3a) back from 
this line on the centre line of the bracket to 
locate the front edge of the lower bracket.  Fix 
lower bracket (with two fixing holes) to the floor 
then measure the height from floor level to 
engagement edge on back of appliance, 
dimension 'C' of Fig. 3b. 

4.  Assemble upper bracket to lower bracket so that 

the underside of bracket is dimension 'C' + 3mm 
above floor level.  (See Fig. 3b) 
Reposition appliance and check that top bracket 
engages into appliance back as shown in Fig. 
3b. 

 

 

1.  The battery is located on the left hand side of the 

front plinth. 

2.  To gain assess to the battery, open the main 

oven door and lift up the battery holder lid. 

3.  Fit the new battery ensuring (+) terminal is next 

to the (+) sign on the battery.  See Fig. 4. 

4.  Close the lid of the battery holder.

Fig.4. 

Fig.3a.

Fig.3b.

Fig.2. 

Fig.4.