Amana ARG7800 ユーザーズマニュアル

9

Converting Type 2 Pressure Regulator for Use with
LP/Propane
1.

Remove pressure regulator cap with a 

 

 wrench.

2.

Reverse pressure regulator cap.
• Cap must show “LP”.

3.

Place pressure regulator cap on pressure regulator
and tighten.

Cap

LP

Type 2 Pressure Regulator

Converting Surface Burners for Use with LP\Propane
1.

Remove 4 burner control knobs from range.
• Exposes 2 screws on burner control panel.

2.

Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.

3.

Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,

continue to roll panel until free from range. Set
aside. See

 Pivot Point in figure.

• Gas valve and orifice hood are visible after burner

control panel is removed.

A

B

C

D

A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw

Burner Control Panel

4.

While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
• Use ½ inch open end or 90° offset open end

wrench.

• Do not over tighten orifice hoods. If orifice hoods are

over tightened, gas supply can be cutoff or orifice
hoods can strip.

5.

Open air shutter fully.

A

B

Open Fully

A—Orifice Hood
B—Air Shutter

Converting Surface Burners for Use with LP\Propane

6.

Reassemble burner control panel after adjusting air
shutter.
• See

 Adjusting Surface Burner Flame section.