Perlick BBRN ユーザーズマニュアル

Printed in USA 

12 

0213

If the unit appears to be malfunctioning, read through the Operation section in this manual first. If the 

problem persists, check through this troubleshooting section. Locate the problem and refer to the cause 

and remedy before calling for service. The problem could be something that can be solved without a 

service call.

No interior light.

Rocker switch in Off position.

Turn switch on.

LED board inoperable.

Contact your selling dealer.

Light stays on when door is 

closed.

Manual switch on.

Turn manual switch off.

Noisy operation.

Soft sounds from compressor, fan 

motor and valves heard.

Normal operation.

LED Controller display is flashing 

.“P1”.

Thermostat probe failure. 

Contact your selling dealer.

LED Controller display is flashing 

“HA”.

Internal compartment has exceeded the 

high temperature alarm preset value for 

over 30 minutes.

Make sure door is completely closed.

Check door gasket seal. Replace if 

necessary. 

Check condenser and clean if necessary.

Make sure louvered plate is unobstructed.

If surrounding ambient temperature has 

changed dramatically recently, compartment 

temperature may be affected.

Make sure interior light is off.

Warm product placed in cabinet recently. Wait 

24 hours for product to chill then recheck 

temperature.

LED Controller display is flashing 

“LA”.

Internal compartment has exceeded the 

low temperature alarm preset value for 

over 30 minutes.

Make sure door is completely closed.

Check door gasket seal. Replace if 

necessary.

If surrounding ambient temperature has 

changed dramatically recently, compartment 

temperature may be affected.

LED Controller display is flashing 

“EE”.

Controller has a data or memory failure. Reset both compartment presets.

If problem persists, contact your Perlick 

Service Department.

Unit is not running.

No power to the unit. 

Condenser dirty.

Home circuit breaker tripped. Reset circuit 

breaker.

ON/OFF keypad is off. Turn on.

Clean the condenser.

Compartments are warmer than 

usual.

Control preset not set properly.

Light staying on.

Condenser dirty or obstructed.

Door is open or has been opened more 

frequently lately.

Internal louvers and/or fan guard 

obstructed.

Warm product placed in cabinet 

recently.

Reset compartments presets.

Turn manual light switch off.

Clean condenser and clear obstruction.

Wait 24 hours and recheck temperature. 

Reset preset temperature if necessary.

Make sure louvers and/or fan is not 

obstructed.