3D Innovations NC60 ユーザーズマニュアル
Upgrading the Printer Software
Chapter 4: Maintaining the Printer
❖
4-21
Procedure A
Upgrade from CentreWare DP
Once the upgrade process has begun do not power
off your printer!
off your printer!
1
Print a Configuration Sheet and a Diagnostics Page.
Keep these pages for future reference. For directions on
doing this, refer to Table 1.20 on page 1-101.
Keep these pages for future reference. For directions on
doing this, refer to Table 1.20 on page 1-101.
2
Start the CentreWare DP software from your workstation.
Select the printer from the Printers List.
Select the printer from the Printers List.
3
At the CentreWare DP main screen select the Tools menu.
4
From the Tools menu select the Upgrade Printer item.
5
Select the Printer button.
6
Enter the path of the upgrade file and click OK.
7
CentreWare DP will send the upgrade file to the printer.
The upgrade should take less than 10 minutes to perform.
The upgrade should take less than 10 minutes to perform.
8
To see if your upgrade was successful see the section
“Determining a Successful Upgrade” (page 4-20). If
successful, follow the instructions in the section “After the
Upgrade” (page 4-20). For problems consult the section
“General Troubleshooting” (page 4-32).
“Determining a Successful Upgrade” (page 4-20). If
successful, follow the instructions in the section “After the
Upgrade” (page 4-20). For problems consult the section
“General Troubleshooting” (page 4-32).