Liebherr 110309 7084282 - 01 ユーザーズマニュアル

Fig. 4 

u

Lift off the covers

 Fig. 4 (5,6,7,8)

 forwards using a flat-blade

screwdriver.

u

Loosen the top and bottom screws

 Fig. 4 (9)

 on the appliance

body, without removing them.

u

Pull the doors outwards and detach them.

u

Transfer the screws

 Fig. 4 (9)

 to the opposite side and screw

them in a little.

u

Undo the screws

 Fig. 4 (10)

 and change over the hinges di-

agonally.

The screws

 Fig. 4 (10)

 are self-tapping: use a cordless screw-

driver.

u

Screw the hinges tight.

u

Place plugs

 Fig. 4 (11)

 in the now unused fastening holes.

u

Attach the doors to the prefitted screws

 Fig. 4 (9)

 and tighten

the screws.

Fig. 5 

u

Fasten ball stud

 Fig. 5 (3)

 in the new fastening hole.

u

Push tension spring

 Fig. 5 (11)

 inwards again.

u

Screw on holder

 Fig. 5 (1)

.

u

Attach soft stop mechanism

 Fig. 5 (2)

 to ball stud.

Danger of electric shock!

u

Disconnect the appliance by unplugging it before you connect

it to the water line.

u

Shut off the water supply before you connect the water feed

lines of the IceMaker.

u

The connection to the drinking water system may be carried

out only by a qualified gas fitter and plumber.

Risk of poisoning!

u

The water quality has to comply with the drinking water ordi-

nance of the respective country (e.g. 98/8

u

The  IceMaker  serves  exclusively  for  making  ice  cubes  in

household quantities and has to be operated with water suit-

able for the purpose.

- The  water  pressure  has  to  be  be-

tween 0.15 MPa and 0.6 MPa. (1.5

bar- 6 bar)

- The  water  supply  to  the  appliance

must be via a cold water pipe which

withstands  the  operating  pressure

and complies with the hygiene regu-

lations.

Use  the  accompanying  stainless

steel hose (1.5 m). Do not reuse old

hoses. A 3 m hose is available from

the customer service department and

has to be fitted by an expert.

In  the  hose  connecting  piece  is  a

sieve with seal.

- Between the hose and the domestic

water  connection  there  has  to  be  a

stopcock to interrupt the water supply

in case of need.

- All  the  fixtures  and  fittings  used  for

water supply have to comply with the

applicable regulations of the respec-

tive country.

- Do not damage or kink the water inlet

pipe when installing the appliance.

u

Connect the straight part of the accompanying stainless steel

hose to the stopcock.

The solenoid valve is at the bottom back of the appliance. It has

a metric R3/4 connecting thread.

u

Connect the angled part of the stainless steel hose to the sol-

enoid valve.

u

Open the stopcock of the water supply and check

that the entire water system is leakproof.

Before initial use:

u

Have the water pipe bled of air by the proper ex-

pert.

All the mounting components accompany the appliance.