Elkay HRC32W プリント

97582C (01/21/2000)

It is important to insure proper ventilation. A minimum of 6 inches

    (152mm) to the front must be maintained, and 6 inches (152mm) to the rear of the unit. 2. This chiller has been designed for use with potable water 

and includes an o-ring seal on the drain plug. This

    fitting should be replaced if the unit is to be used with more aggressive fluids. 3. Installer to provide air gap

 at condenser water outlet to comply with local plumbing specifications.

Thoroughly flush all lines to remove all foreign matter before connecting to

    cooler. If flushing does not remove all particles, a water strainer should be installed in the supply line. 5. Connect cooler to building supply 

with a shut-off valve and install a union connection between the valve and the

    cooler. 6. Electrical:  Make sure power supply is identical

 in voltage, cycle, and phase to that specified on cooler serial plate.

    Never wire the compressor directly to the power supply.