Frigidaire A01060901 オーナーマニュアル

12

Your new Pure Advantage air filter is located 

inside one of the 2-Liter Door Bins. The air 

filter cover is located on the upper right side 

of the control box.  In general, you should 

change the air filter with Part Number “EAFCBF” 

every six months to ensure optimal filtering of 

freezer odors.  The replacement air filter can 

be purchased on the Frigidaire website (http://

frigidaire.stores.yahoo.net) or call toll free in 

the U.S. and Canada: 1-800-599-7569. Your 

electronic control is equipped with a Replace 

Filter indicator to remind you to change your 

filter. See ELECTRONIC CONTROL section.
To Install Or Replace The Air Filter

•  Pull down on the front of the Pure 

Advantage™ air filter cover to release the 

hinged bottom cover.

•  Allow bottom cover to swing open and then 

remove the old filter and discard it.

•  Unpackage the new filter and place it inside 

the hinged bottom cover of the housing.

•  Push the hinged bottom cover upward until 

the tab snaps into closed position.

replace air filter

hold to reset

press & hold

air

filter

temp

mode

alarm

off

control

lock

Air Filter

To avoid electric shock, which can cause death 

or severe personal injury, disconnect the 

freezer from electrical power before connecting 

a water supply line to the freezer.

• Copper or Stainless Steel braided tubing 

is recommended for the water supply line. 

Water supply tubing made of ¼ inch plastic is 

not recommended to be used. Plastic tubing 

greatly increases the potential for water leaks, 

and the manufacturer will not be responsible 

for any damage if plastic tubing is used for the 

supply line.
• DO NOT install water supply tubing in areas 

where temperatures fall below freezing.
• Chemicals from a malfunctioning softener 

can damage the ice maker. If the ice maker 

is connected to soft water, ensure that the 

softener is maintained and working properly.



Ensure that your water supply line connections 

comply with all local plumbing codes.

•  Basic Tools: adjustable wrench, flat-blade 

screwdriver, and Phillips

TM

 screwdriver.

•  Access to a household cold water line with 

water pressure between 30 and 100 psi.

•  A water supply line made of ¼ inch (6.4 mm) 

OD, copper or stainless steel tubing. To deter-

mine the length of tubing needed, measure 

the distance from the ice maker inlet valve at 

the back of the freezer to your cold water pipe. 

Then add approximately 7 feet (2.1 meters), 

so the freezer can be moved out for cleaning 

(as shown).

•  A shutoff valve to connect the water supply 

line to your household water system. DO NOT 

use a self-piercing type shutoff valve.

•  A compression nut and ferrule (sleeve) for con-

necting a copper water supply line to the ice 

maker inlet valve.