Frigidaire 242111900 オーナーマニュアル

15

To order your replacement filters, please visit our online

store at www.frigidaire.com/store, by calling toll-free 

at 877-808-4195, or by visiting the dealer where you 

purchased your refrigerator. Frigidaire recommends that you 

order extra filters when you first install your refrigerator, and

that you replace your filters at least once every six months.

The water filter is located at the top right side of the fresh

food compartment. 

In general, you should change the water filter every six

months to ensure the highest possible water quality. Water 

Filter Status on the user interface prompts you to replace 

the filter after a standard amount of water (200 gallons/757

liters for PureSource 3

TM

)

 

has flowed through the system.

If your refrigerator has not been used for a period of time 

(during moving for example), change the filter before

reinstalling the refrigerator.

Do not use with water that is microbiologically unsafe or of 

unknown quality without adequate disinfection before or after 

the system. Systems certified for cyst reduction may be used

on disinfected waters that may contain filterable cysts.

 •  Rated Capacity - 200 gallons/757 liters for

TM

ice and water filter

 •  Rated service flow - .50 gallons per minute
 •  Operating Temp.: Min. 33°F, Max. 100°F
 •  Maximum Rated Pressure - 100 pounds per square inch
 •  Recommended Minimum Operating Pressure: 30

pounds per square inch

TM

It is not necessary to turn the water supply off to change 

the filter. Be ready to wipe up any small amounts of water

released during the filter replacement.
  1  Turn Off the ice maker power switch.   
  2  Remove the filter by pushing on the end/face of the

filter.

  3  Slide the old water filter cartridge straight out of the

housing and discard it.

  4  Unpackage the new filter cartridge. Using the

alignment guide, slide it gently into the filter housing

until it stops against the snap-in connector at the 

back of the housing.

  5  Push firmly until the cartridge snaps into 

engages the snap-in connector). 

  6  Press a drinking glass against the water dispenser 

while checking for any leaks at the filter housing.

Any spurts and sputters that occur as the system 

purges air out of the dispenser system are normal.

  7  After filling one glass of water, continue flushing the

system for about four minutes.

  8  Turn On the ice maker.
  9  Press and hold the Water Filter

button on the Ice 

& Water Dispenser control panel for three seconds. 

When the display changes from red to Green, the 

status has been reset.

The PureSource 3

TM 

ice and water filter

system is tested and certified to NSF/ANSI

Standards 42 and 53 for the reduction of claims 

specified on the performance data sheet.

The air filter is located at the top of the fresh food

compartment next to the water filter.

In general, you should change the air filter every six

months (the filter status light on the control panel prompts

you to replace the filter after six months) to ensure optimal

filtering of refrigerator odors. You may want to adjust this

time period depending on the types and amounts of food 

you typically store in your refrigerator.  To replace you 

TM

air filter:

  1  Pull the air filter housing straight out.
  2  Remove the old filter and discard it.
  3  Unpack the new filter and place it inside the housing.
  4  Slide the housing back into position.

Here is the product number to request when ordering: 
  PureSource 3

TM 

Water Filter

  Part #WF3CB

TM

 Air Filter

  Part #PAULTrA