Frigidaire FFHS2313LP ユーザーズマニュアル

23

Your refrigerator is equipped with a water filtering

system. The water filter system filters all dispensed

drinking water, as well as the water used to 

produce ice.

The water filter is located at the top right side of

the fresh food compartment.

Do not use with water that is microbiologically 

unsafe or of unknown quality without adequate

disinfection before or after the system. Systems 

certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

•  Rated Capacity - 200 gallons/757 liters for 

 and PureSource 3

 

ice and water filter

•  Rated service flow - .50 gallons per minute
•  Operating Temp.: Min. 33°F,  Max. 100°F
•  Maximum Rated Pressure - 100 pounds per 

square inch

•  Recommended Minimum Operating Pressure: 

30 pounds per square inch

It is not necessary to turn the water supply off 

to change the filter. Be ready to wipe up any

small amounts of water released during the filter

replacement.
  1 Turn Off the ice maker.

  2  Remove the filter by pushing on the end/face

of the filter.

  3  Slide the old water filter cartridge straight out

of the housing and discard it.

  4  Unpackage the new filter cartridge. Using

the alignment guide, slide it gently into the 

filter housing until it stops against the snap-in

connector at the back of the housing.

  5  Push firmly until the cartridge snaps 

  6  Press a drinking glass against the water 

dispenser while checking for any leaks at the 

filter housing. Any spurts and sputters that

occur as the system purges air out of the 

dispenser system are normal.

  7  After filling one glass of water, continue

flushing the system for about four minutes.

  8 Turn On the ice maker.

  9  Press and hold the Water Filter button on 

the Ice & Water Dispenser control panel for 

three seconds. When the display changes from 

“Red” to “Green,” the status has been reset.

To order your replacement filters, please visit our

online store at www.frigidaire.com/store, by calling 

toll-free at 877-808-4195, or by visiting the dealer 

where you purchased your refrigerator. Frigidaire 

recommends that you order extra filters when you

first install your refrigerator, and that you replace

your filters at least once every six months.
Here are the product numbers to request when

ordering:
  PureSource Ultra

 Water Filter

 Part# 

  PureSource 3

TM 

Water Filter

  Part #WF3CB

In general, you should change the water filter every six

months to ensure the highest possible water quality.

Water Filter Status on the user interface prompts 

you to replace the filter after a standard amount of

water (200 gallons/757 liters for PureSource Ultra

 

andPureSource 3

)

 

has flowed through the system.

If your refrigerator has not been used for a period of 

time (during moving for example), change the filter

before reinstalling the refrigerator.

Filter Cartridge

The PureSource 3

TM 

ice and water 

filter system is tested and certified to

NSF/ANSI Standards 42 and 53 for 

the reduction of claims specified on

the performance data sheet.



If your refrigerator is equipped with a PureSource 

water filter, it can be replaced with a

water filter. Replacing your

water filter with a PureSource 

water filter removes more potential

contaminants as tested by NSF. The contaminants 

or other substances removed or reduced by this 

water filter are not necessarily in all users’ water.



If your refrigerator is equipped with a PureSource 

water filter, it must be replaced with

water filter ULTRAWF.

The PureSource Ultra

TM 

ice and 

water filter system is tested and

certified to NSF/ANSI Standards 42 and

53 for the reduction of claims specified

on the performance data sheet.