Frigidaire FPHG2399MF ユーザーズマニュアル

11



All set screws should be 

tightened so the screw is below 

the surface of the handle. The 

handles should be drawn tight 

to freezer and refrigerator doors 

with no gaps. Opening the 

opposite door while tightening 

the Allen screw makes 

installation easier.
The door handle may loosen 

over time or if it was installed 

improperly. If this happens, 

tighten the set screws on the 

handles.

  1  Remove handles from carton and any other protective packaging.
  2  Position fresh food handle end over upper and lower pre-installed shoulder bolts (A) 

that are fastened into door, ensuring the holes for the set screws are facing towards the 

opposite door.

  3  While holding handle firmly against door, fasten upper and lower Allen set screws (B) with

supplied Allen wrench.

  4  Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing 

towards the first door.

  5  Position freezer handle end over left and right pre-installed handle mounts that are fastened 

to the door, ensuring the holes for the set screws are facing down.

  6  While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied

Allen wrench until there is no gap between handle and door.

  7  Still holding the handle firmly to the door, firmly tighten far left Allen set screw (B) with supplied Allen

wrench.

  8  Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.

Wear gloves and safety goggles. 
Use extreme CAUTION when 
installing these handles.