Frigidaire FGUS2645LF ユーザーズマニュアル

23

Your refrigerator is equipped with water

filtering system. The water filter system filters

all dispensed drinking water, as well as the 

water used to produce ice.

The water filter is located at the top right side

of the fresh food compartment. 

To order your replacement filters, please visit our

online store at www.frigidaire.com/store, by calling 

toll-free at 877-808-4195, or by visiting the dealer 

where you purchased your refrigerator. Frigidaire 

recommends that you order extra filters when you

first install your refrigerator, and that you replace

your filters at least once every six months.
Here is the product number to request when ordering:
  PureSource Ultra

TM 

Water Filter

  Part #ULTRAWF

In general, you should change the water filter every

six months to ensure the highest possible water 

quality. The Water Filter Status light on the user 

interface prompts you to replace the filter after a

standard amount of water (200 gallons/757 liters 

for PureSource Ultra

TM

)

 

has flowed through the

system. The water filter status light on this model is

not performance tested or certified by NSF.
If your refrigerator has not been used for a period 

of time (during moving for example), change the 

filter before reinstalling the refrigerator.

Do not use with water that is microbiologically 

unsafe or of unknown quality without adequate

disinfection before or after the system. Systems 

certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

•  Rated Capacity - 200 gallons/757 liters for 

PureSource Ultra

TM

ice and water filter

•  Rated service flow - .50 gallons per minute
•  Operating Temp.: Min. 33°F,  Max. 100°F
•  Maximum Rated Pressure - 100 pounds per 

square inch

•  Recommended Minimum Operating 

Pressure: 30 pounds per square inch

It is not necessary to turn the water supply off 

to change the filter. Be ready to wipe up any

small amounts of water released during the 

filter replacement.
  1 Turn Off the ice maker by raising the wire 

signal arm.

  2  Remove the filter by pushing on the end/

face of the filter.

  3  Slide the old water filter cartridge straight

out of the housing and discard it.

  4  Unpackage the new filter cartridge. Using

the alignment guide, slide it gently into the 

filter housing until it stops against the snap-

in connector at the back of the housing.

  5  Push firmly until the cartridge snaps 

  6 Turn On the ice maker by lowering the wire 

signal arm.

  7  Press and hold the Water Filter

button on the 

Ice & Water Dispenser control panel for three 

seconds. When the display changes from Red 

to Green, the status has been reset.

  8  After replacing the water filter and in order for

the ice maker to work properly, it is necessary 

to clear air from water filter tubing. Once ice

maker begins making ice, allow the bucket to 

fill completely, then discard the first TWO FULL

buckets of ice. It will take at least two days 

to completely fill the bucket on regular ice

making mode or 1 

1

/

2

 days on fast ice mode.

The PureSource Ultra

TM 

ice and water 

filter system is tested and certified to

NSF/ANSI Standards 42 and 53 for the 

reduction of claims specified on the

performance data sheet.



If your refrigerator is equipped with a

PureSource Ultra

TM

water filter, it must be

replaced with PureSource Ultra

TM

filter ULTRAWF.