Frigidaire FFHT2126LS ユーザーズマニュアル

4



If your refrigerator is placed with the door hinge side 

against a wall, you may have to allow additional space 

so the door can be opened wider.



Raise the front of the refrigerator enough so the doors 

close freely when opened halfway.  The refrigerator 

should slope 1/4” to 1/2” from front to back.  Then 

level the refrigerator from side-to-side.

Do Not install the refrigerator where the temperature 

will drop below 55°F (13°C) or rise above 110°F 

(43°C).  The compressor will not be able to maintain 

proper temperatures inside the refrigerator.
Do Not block the toe grille on the lower front of your 

refrigerator. Sufficient air circulation is essential for the

proper operation of your refrigerator.

This Use & Care Guide provides general operating 

instructions for your model. Use the refrigerator only as 

instructed in this Use & Care Guide. Before starting the 

 •  Choose a place that is near a grounded electrical

outlet. Do Not use an extension cord or an 

adapter plug.

 •  If possible, place the refrigerator out of direct

sunlight and away from the range, dishwasher or 

other heat sources.

 •  The refrigerator must be installed on a floor that is

level and strong enough to support a fully loaded 

refrigerator.

 •  Consider water supply availability for models

equipped with an automatic ice maker. If you do 

not hook up water to the refrigerator, remember to 

turn the ice maker off.

Installation clearances

 •  Allow the following clearances for ease of

installation, proper air circulation, and plumbing 

and electrical connections:

 

Sides & Top 

3

/

8

 inch

 

Back   

1 inch

All four corners of your refrigerator must rest firmly on a

solid floor. Your refrigerator is equipped with adjustable

front rollers or front leveling screws to help level your 

unit.
To level your refrigerator:
  1  Remove toe grille.
  2  Use flat-blade screwdriver or 3/8” socket wrench

to adjust front rollers.  Use adjustable wrench to 

adjust leveling screws.