Frigidaire FRS23R4AQ6 ユーザーズマニュアル

24

•  Ice maker is producing less ice

than you expect.

•  Freezer is not cold enough.

•  Household water line valve is

not completely open.

•  Check to see if water

dispenser is dispensing slower
than normal.

•  Ice maker should produce approximately 4 – 5 pounds

of ice every 24 hours. Extra Ice should produce up to 8
pounds of ice every 24 hours.

• See 

PROBLEM section TEMPERATURES ARE TOO

•  Turn on household water line valve.

•  If it is, replace the ice & water filter cartridge.

•  Ice maker wire signal arm is

being held down by some item
in the freezer.

•  Move item and release wire signal arm. Remove any

ice cubes that are frozen together over the wire signal
arm.

•  Ice cubes are not being used

frequently enough.

•  Ice cubes are hollow or smaller

than normal.

•  Remove and shake ice container to separate cubes.

•  The ice & water filter cartridge may be clogged.

Replace filter cartridge.

•  Ice has picked up odor or

flavor from strong food stored
in refrigerator or freezer.

•  Water running to ice maker

has poor taste or odor.

•  Ice not used frequently enough.

•  Cover foods tightly. Discard stale ice. Ice maker will

produce fresh supply.

•  Add filter to water supply line. Consult a water

purifying company.

• Discard 

stale 

ice.

•  Ice storage container is empty.

•  Freezer temperature is set too

warm.

•  Household water line valve is

not open.

•  Freezer door is not closed.

•  Ice dispensing arm has been

held in for more than 4-5
minutes.

•  When the first supply of ice is dropped into the

container, the dispenser should operate.

•  Turn freezer control to a higher setting so that ice

cubes will be made. When first supply of ice is made,
dispenser should operate.

•  Open household water line valve. Allow sufficient time

for the ice to be made. When ice is made, the
dispenser should operate.

•  Ensure freezer door is closed.

•  Motor is overloaded. Motor overload protector will

reset in approximately 3 minutes. Ice can then be
dispensed.

•  Ice has melted and frozen

around auger due to infrequent
use, temperature fluctuations,
and/or power outages.

•  Ice cubes are jammed

between ice maker and back
of ice container.

•  Ice cubes are frozen together.

•  Ice cubes are hollow or smaller

than normal.

•  Remove ice container, thaw, and empty the contents.

Clean container, wipe dry, and replace in proper
position. When new ice is made, dispenser should
operate.

•  Remove ice cubes that are jamming the dispenser.

•  Use the dispenser often so that cubes do not freeze

together.

•  The ice & water filter cartridge could be clogged.

Replace the filter cartridge. Dispensing system
operates best at 20 – 100 psi water pressure. Well
water pressures should fall within this range.