Frigidaire FPHF2399MF ユーザーズマニュアル

ページ / 41
18
CONNECTING THE WATER SUPPLY
Figure 1
To Connect Water Supply Line To 
Ice Maker Inlet Valve
1.  Disconnect refrigerator from electric 
power source.
2.  Place end of water supply line into sink 
or bucket. Turn ON water supply and 
flush supply line until water is clear.
Turn OFF water supply at shutoff valve.
3.  Remove plastic cap from water valve 
inlet and discard cap.
4.  If you use copper tubing - Slide 
brass compression nut, then ferrule 
(sleeve) onto water supply line. Push 
water supply line into water valve inlet 
as far as it will go (¼ inch/6.4 mm). 
Slide ferrule (sleeve) into valve inlet and 
finger tighten compression nut onto
valve. Tighten another half turn with 
a wrench; DO NOT overtighten. See 
Figure 1.  
If you use stainless steel tubing 
- The nut and ferrule are already 
assembled on the tubing. Slide 
compression nut onto valve inlet and 
finger tighten compression nut onto
valve. Tighten another half turn with 
a wrench; DO NOT overtighten. See 
Figure 1.
5.  With steel clamp and screw, secure 
water supply line (copper tubing only) 
to rear panel of refrigerator as shown. 
6.  Coil excess water supply line (copper 
tubing only), about 2½ turns, behind 
refrigerator as shown and arrange coils 
so they do not vibrate or wear against 
any other surface. Do not kink tubing.
7.  Turn ON water supply at shutoff valve 
and tighten any connections that leak.
8.  Reconnect refrigerator to electrical 
power source.
9.  To turn ice maker on, lower wire signal 
arm (freezer ice maker) or set the ice 
maker’s On/Off power switch to the 
“On” position (fresh food ice maker).
Steel
Clamp
Brass
compression
Nut
Ferrule
(Sleeve)
Water
line
Water Valve
Bracket
Valve Inlet
Water Valve
Water line from
household water
supply
(Include enough tubing on loop to allow
moving refrigerator out for cleaning.)
Plastic Water Tubing
to Ice Maker
Fill Tube
IMPORTANT
After connecting the water supply, refer to 
“How to Prime the Water Supply System” 
for important information about priming an 
empty water supply system. 
Your refrigerator’s water supply system 
includes several tubing lines, a water filter,
a water valve, and a water tank. To ensure 
that your water dispenser works properly, this 
system must be completely filled with water
when your refrigerator is first connected to
the household water supply line.