Frigidaire FGUS2647LF ユーザーズマニュアル

Your ice maker is turned on at the factory 

so it can work as soon as you install your 

refrigerator. If you cannot connect a water 

supply, lift the ice maker’s wire signal arm 

to turn it off. Otherwise, the ice maker’s 

fill valve may make a loud chattering noise

when it attempts to operate without water.

If the water supply to your refrigerator is 

softened, be sure the softener is properly 

maintained. Chemicals from a water softener 

can damage the ice maker.

NEVER use an ice pick or similar sharp 

instrument to break up the ice. This 

could damage the ice bin and dispenser 

mechanism.
To loosen stuck ice, use warm water. 

Before replacing the ice bin, make sure it is 

completely dry.

17

After the refrigerator is installed properly, the 

ice maker can produce ice within 24 hours. It 

can completely fill an ice bin in about three (3)

days.
When using the ice maker for the first time and

in order for the ice maker to work properly, it is 

necessary to clear air from water filter tubing.

Once ice maker begins making ice, allow the 

bucket to fill completely, then discard the first

TWO (2) FULL buckets of ice. It will take at 

least two (2) days to completely fill the bucket

on regular ice making mode or 1 

1

/

2

 days on 

fast ice mode.
The ice maker produces approximately four 

(4) pounds of ice every 24 hours depending on 

usage conditions.

Ice production is controlled by lifting/lowering 

the ice maker’s wire signal arm. To gain 

access to the ice maker, pull the freezer drawer 

out. Lift the wire signal arm to turn the ice 

maker OFF and lower the wire signal arm to 

turn it ON.

Clean the ice maker and ice bin at regular 

intervals, especially prior to vacation or moving.
  1  Turn off the ice maker.
  2  Remove the ice bin.
  3  Empty and carefully clean the ice bin 

with mild detergent. Do not use harsh or 

abrasive cleaners. Rinse with clean water.

  4  Allow the ice bin to dry completely before 

replacing in the freezer.

  5  Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if:

•  An extended power failure (one hour or 

longer) causes ice cubes in the ice bin to 

melt and freeze together.

Remove the ice bin and shake to loosen the 

cubes or clean as explained above.

•  If your refrigerator is not connected to a water 

supply or the water supply is turned off, turn 

off the ice maker by lifting wire signal arm. 

•  The following sounds are normal when the 

ice maker is operating:

 

-  Motor running

 

-  Ice dropping into ice bin

 

-  Water valve opening or closing

 

-  Running water

•  Ice cubes stored too long may develop an odd 

flavor. Empty the ice bin as explained below.

Your refrigerator is equipped with a Quick Ice

Function, that increases ice production. This 

function terminates automatically.