Frigidaire DGHF2360PF オーナーマニュアル

13

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.



All set screws should be tightened so the screw is below 

the surface of the handle. The handles should be drawn 

tight to freezer and refrigerator doors with no gaps. 

Opening the opposite door while tightening the Allen 

screw makes installation easier.
The door handle may loosen over time or if it was 

installed improperly. If this happens, tighten the set 

screws on the handles.

  1  Remove handles from carton 

and any other protective 

packaging.

  2  Position fresh food handle 

end caps over upper and 

lower pre-installed shoulder 

bolts (A) that are fastened 

into door, ensuring the holes 

for the set screws are facing 

towards the opposite door.

 3  While holding handle firmly

against door, fasten upper 

and lower Allen set screws 

(B) with supplied Allen 

wrench.

  4  Repeat steps 2 and 3 to 

install opposite handle. 

Ensure the holes for the set 

screws are facing towards 

the first door.

  5  Position freezer handle end 

caps over left and right 

pre-installed shoulder bolts 

that are fastened to the door, 

ensuring the holes for the set 

screws are facing down.

 6  While holding handle firmly

against door, loosely tighten 

right Allen set screw (B) with 

supplied Allen wrench until 

there is no gap between 

handle and door.

 7  Still holding the handle firmly

to the door, firmly tighten

left Allen set screw (B) with 

supplied Allen wrench.

  8  Return to the right Allen set 

screw (B) and firmly tighten

with supplied Allen wrench.