Frigidaire DGHF2360PF オーナーマニュアル
7
INSTALLATION
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
• Doors should align with each other and be
level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front
To level the cabinet using the front
rollers:
Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1 Check gasket seal around top, bottom, and sides of freezer drawer.
2 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each
1 Check gasket seal around top, bottom, and sides of freezer drawer.
2 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each
side) to allow drawer to rotate.
3 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
4 Tighten four drawer screws.
5 Recheck gasket seal.
5 Recheck gasket seal.
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must rest
firmly on the floor.
• The sides should tilt ¼ inch (6 mm) from
front to back (to ensure that doors close
and seal properly).
Push
Against
Freezer
Drawer
Grab Drawer
At Center
From Both
Sides Then
Pull Drawer
Out
A
B
1 Slightly open freezer drawer. Lift the
toe grille and gently pull forward (see
illustration).
2 You can raise or lower each door. Use
a ⅜ inch socket wrench to turn the
adjustment screws (one per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
To lower: turn adjustment screw
counterclockwise.
3 Ensure both doors are bind-free with their
seals touching the cabinet on all four sides
and that cabinet is stable.
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw