Frigidaire FFHS2313LS ユーザーズマニュアル

ページ / 30
6
INSTALLATION
NOTE
T
he refrigerator doors are designed to shut 
by themselves within a 20 degree opening.
Raise
Door Opening
Your refrigerator should be positioned to 
allow easy access to a counter or table when 
removing food. For best use of drawers and 
freezer baskets, the refrigerator should be 
in a position where both the refrigerator and 
freezer doors can be fully opened.
Guidelines for final positioning of 
your refrigerator:
•  All four corners of the cabinet must rest 
firmly on the floor.
•  The cabinet should be level at the front 
and rear.
•  The sides should tilt ¼ inch (6 mm) from 
front to back (to ensure that doors close 
and seal properly).
•  Doors should align with each other and be level.
All of these conditions can be 
met by raising or lowering the 
adjustable front rollers.
To level the cabinet using the front rollers:
  1  Open both doors and remove the toe 
grille (see “Toe Grille Installation and 
Removal” in the “Installation” section).
  2  Close the doors and use a flat-blade
screwdriver or 
3
/
8
  inch socket wrench to 
raise or lower the front rollers.
  3  Ensure both doors are bind-free with their 
seals touching the cabinet on all four sides.
Set Screw
(some models)
Hinge
Hinge
Flange
Open Door
Door Stop
Flange
7/16" Wrench
and 
3/32" Hex Key
(some models)
  6  Replace the toe grille by fitting it into
place (see “Toe Grille Installation and 
Removal” in the “Installation” section).
Raise
Door
Door
Raise
Door
Door
To level the doors using the adjustable 
lower hinge:
  4  After leveling, verify door stop contacts 
lower hinge and top of door does not 
contact upper hinge through full movement 
of door (from fully closed to fully open).
  5  Reinstall set screw, locking the door height.
NOTE
Some models will not have a set screw. For 
those models follow steps 2 through 4.
  1  Before leveling either door, remove set 
screw that locks door height into position. 
(The door cannot be adjusted without set 
screw removed).
  2  If the refrigerator door is lower than the 
freezer door, raise the refrigerator door by 
turning the adjustment screw clockwise 
using a 
7
/
16  
inch wrench. (See illustration.)
  3  If the freezer door is lower than the 
refrigerator door, raise the freezer door by 
turning the adjustment screw clockwise 
using a 
7
/
16  
inch wrench. (See illustration.)