Frigidaire LGHC2342LF3 ユーザーガイド

13

Your ice maker is shipped from the factory with the 

wire signal arm in the ON position (side mounted) or 

with the switch turned ON (rear mounted). To ensure 

proper function of your ice maker, hook up water 

supply immediately or turn ice maker OFF by lifting 

the wire signal arm until it clicks and locks in the UP 

position (side mounted) or turn the On/Off switch to 

the Off (0) position (rear mounted). If the ice maker is 

not turned off and the water supply is not connected, 

the water valve will make a loud chattering noise..

Your refrigerator’s water supply system includes several 

tubing lines, an advanced water filter, a distribution valve

bank, and a reserve tank to ensure ample supply to the 

ice and water dispenser at all times. This system needs 

to be completely filled with water when first connected to

an external supply line. 

  1  Begin filling the tank by pressing and holding a

drinking glass against the water dispenser paddle.

  2  Keep the glass in this position until water comes 

out of the dispenser. It may take about 1½ 

  3  Continue dispensing water for about three minutes 

to flush the system and plumbing connections of

any impurities (stopping to empty the glass as 

necessary).

The ice maker, ice bin, and dispenser feeding mechanism 

are located in the top of the freezer compartment. After 

the refrigerator is installed properly and has cooled for 

several hours, the ice maker can produce ice within 24 

hours. It can completely fill an ice bin in about two days.

Before making ice for the first time, be sure to prime the

water supply system. Air in new plumbing lines can result 

in two or three empty ice maker cycles. Furthermore, 

if the system is not flushed, the first ice cubes may be

discolored or have an odd flavor.

To begin ice production, lower the wire signal arm to 

the DOWN or ON position. The ice maker turns off 

automatically when the ice container becomes full. To 

stop the ice maker, raise the wire signal arm until it clicks 

and locks in the UP or OFF position.

Ice production is controlled by the ice maker’s ON/OFF 

power switch. To gain access to the ice maker, pull the 

ice cream shelf out. Press the switch to the “O” position 

to turn it Off and press it to the “I” position to turn it On. 

The ice maker also has a built-in wire signal arm, which 

automatically stops ice production when the ice bin is 

full. DO NOT use this signal arm to manually stop the ice 

maker.



The water dispenser has a built-in device that shuts 

off the water flow after three minutes of continuous

use. To reset this shutoff device, simply release the 

dispenser paddle. 

For proper dispenser operation, recommended water 

supply pressure should fall between 30 psi and 100 

psi. Excessive pressure may cause water filter to

malfunction.

Wire

Signal Arm

Produce in 24 Hours?
A side mounted ice maker will produce 4 to 4.5 pounds of 

ice every 24 hours, depending on usage conditions. Ice is 

produced at a rate of 8 cubes every 75 to 90 minutes.
How Much Ice Will a Rear Mounted Ice Maker 

Produce in 24 Hours?
A rear mounted ice maker will produce 3 to 4 pounds of 

ice every 24 hours, depending on usage conditions. Ice is 

produced at a rate of 8 cubes every 75 to 90 minutes.