KitchenAid KSSS36FKX02 ユーザーズマニュアル

The Door Open indicator light will flash, an alarm will sound and 
the interior lights will turn off when a door is open for longer than 
10 minutes. When the door is closed, the sound alarm will reset 
and turn off but the Door Open indicator light will continue to 
flash until the temperature is equal to or below 45°F (7°C) and 
15°F (-9°C) for the refrigerator and freezer compartments 
respectively. You can also reset the Door Open sound alarm by 
pressing the OVER TEMPERATURE RESET. 

Depending on your model, you may have one or more of the 
following options: the ability to select either crushed or cubed 
ice, a special light that turns on when you use the dispenser, or a 
lock option to avoid accidental dispensing.

Ice dispenses from the ice maker storage bin in the freezer. When 
the dispenser lever is pressed: 

■

A trap door opens in a chute between the dispenser and the 
ice bin. Ice moves from the bin and falls through the chute. 

■

When you release the dispenser lever, the trap door closes 
and the ice dispensing stops. The dispensing system will not 
operate when the freezer door is open.

Some models dispense both cubed and crushed ice. Before 
dispensing ice, select which type of ice you prefer. The button 
controls are designed for easy use and cleaning. 

■

For cubed ice, press the CUBE button until the red indicator 
appears in the window above the CUBE button. 

■

For crushed ice, press the CRUSH button until the red 
indicator appears in the window above the CRUSH button. 

For crushed ice, cubes are crushed before being dispensed. This 
may cause a slight delay when dispensing crushed ice. Noise 
from the ice crusher is normal, and pieces of ice may vary in size. 
When changing from CRUSH to CUBE, a few ounces of crushed 
ice will be dispensed along with the first cubes.

Press button for the desired type of ice.

Press a sturdy glass against the ice dispenser lever. Hold the 
glass close to the dispenser opening so ice does not fall 
outside of the glass. 

 You do not need to apply a lot of pressure to 

the lever in order to activate the ice dispenser. Pressing hard 
will not make the ice dispense faster or in greater quantities.

Remove the glass to stop dispensing.

 The first few batches of ice may have an off-flavor 

from new plumbing and parts. Throw the ice away. Also, take 
large amounts of ice from the ice bin, not through the 
dispenser.

If you did not flush the water system when the refrigerator was 
first installed, press the water dispenser bar with a glass or jar 
until you draw and discard 2 to 3 gal. (8 to 12 L) or approximately 
6 to 7 minutes of water after water begins dispensing. It will take 
3 to 4 minutes for the water to begin dispensing. The water you 
draw and discard cleans the system and helps clear air from the 
lines. Allow several hours for the refrigerator to cool down and 
chill water.

 Depending on your model, the small removable 

tray at the bottom of the dispenser is designed to catch small 
spills and allow for easy cleaning. There is no drain in the tray. 
The tray can be removed from the dispenser and carried to the 
sink to be emptied or cleaned.

Press a glass against the water dispenser lever.

Remove the glass to stop dispensing.

 Dispense enough water every week to maintain a fresh 

supply.