Samsung RF266AA ユーザーズマニュアル

 

Setting Up

4.  Remove the fi lter cap and insert the fi lter into the fi lter 

housing.

5.  Slowly turn the water fi lter 90º clockwise to align with the 

printing mark on the cover, locking the fi lter in position. 

Make sure to align the water fi lter label mark with center of 

cover fi lter printing as illustrated. Remember, do not over-

tighten.

You should remove the right side upper glass shelf before installing water fi lters.

Removing any residual matter inside the water 
supply line after installing the water fi lter.

1.  Turn ON the main water supply & turn OFF the valve to 

the water supply line.

2.  Run water through the dispenser until the water runs clear 

(approx. 6-7 minutes). This will clean the water supply 

system and remove air from the lines.

3.  Additional fl ushing may be required in some households. 
4.  Open the Refrigerator door and make sure there are no 

water leaks coming from the water fi lter.

Be sure to fl ush the dispenser thoroughly or water may drip from the dispenser. 

This is due to the fact that there is still air in the line.

Check the amount of water supplied to the ice tray.

1.  When you press the TEST button, the ice cube container is fi lled with water from the water supply 

tap. Check to make sure the amount of water is correct (see the illustration below). 

 

 If the water level is too low, the ice cubes will be small. This is a water pressure problem of the 

main water pipes, not the Refrigerator. If this problem occurs, contact the dealer service center 

for help.

Setting up your French Door Refrigerator

Turn until the label 

aligned.

Separation

of red cap.

Cover fi lter.

Feeler Arm

test button

Check the water level