Multiquip HATZ1D81S-325 ユーザーズマニュアル

1.  Once the engine has started, move the engine throttle 

lever quickly to the

 operation position (Figure 16).

2.  With the throttle lever in the run position, the engine 

speed should be around 2,300 RPM, therefore 

engaging the centrifugal clutch.

3.  Using the direction control lever, move the machine 

backward or forward (Figure 17). When the direction 

control lever is pushed forward, the machine moves 

forward. When pulled backward, the machine moves 

backward.

ALWAYS follow all safety rules in the safety 

section of this manual before operating 

compactor. Keep work area clear of debris 

and other objects that could cause bodily 

injury or damage to the compactor.

Throttle lever

Handle

Idle position

Operation

     position

ALWAYS move the throttle lever quickly without 

hesitation, because increasing the engine speed slowly 

causes the clutch to slip.

Reverse

Neutral

Forward

Direction

    control lever

4.  When the direction control lever is the neutral position, 

the machine vibrates staying at the same location

5.  Compactor traveling speed may drop on soils which 

contain clay, however there may be cases where 

traveling speed drops because the compaction plate 

does not leave the ground surface easily due to the 

composition of the soil. To rectify this problem do the 

following:

• Check the bottom plate to see if clay or equivalent 

material has been lodge in the plate mechanism. If so, 

wash with water and remove.

• Remember the compactor does not work as efficiently 

on clay or soils that have a high moisture content level.

• If the soil has a high moisture level, dry soil to 

appropriate moisture content level or carry out 

compaction twice.

1.  Move the throttle lever to the 

idle position (Figure 18) 

and run the engine for three minutes at low speed.

NEVER  stop the engine suddenly while working at 

high speeds.

Throttle lever

Handle

Idle position

Operation

     position