Kenmore 31133 ユーザーズマニュアル

11

1.  Construct wood wall framing that is fl ush with surface of wall 

studs.

  Wood wall framing must be at least 1/2” thick and 3” high. 

Ensure to assemble wood wall framing to wall studs for a 

solid installation.

  Ensure the height of the framing will allow the mounting 

bracket to be secured to the framing within the dimensions 

shown (see illustration beside).

  After wall surface is fi nished, carefully center and level the 

hood mounting bracket over installation location. Secure it 

to wall framing using 3 no. 8 x 1½” screws.

  Using a level, draw a vertical line up to the ceiling starting 

from the mounting bracket center.

HD0374A

2.  Center the upper fl ue mounting bracket with the center line 

previously drawn and place it fl ush with the ceiling.

  Use the upper fl ue mounting bracket as a template to mark 

the position of its screws. 

  Drill the 3 screw holes using a 3/16” drill bit.

  Insert the included drywall anchors into the drilled holes 

(1 per hole).

  Secure the upper fl ue bracket to the wall using 3 no. 8 x 3/4” 

screws.

  Ensure that the bracket is tight against the wall.

HD0377

3. Align the hood and center it above the hood mounting 

bracket. Gently lower the hood until it securely engages the 

bracket.

  Level the hood.

  With the hood hanging in place, secure it to the wall through 

both holes located in the inside upper back of hood using 

2 no. 8 x 1½” screws.

  Drill through both holes located in the inside lower back 

of hood using a 3/16” drill bit. Insert the included drywall 

anchors into the drilled holes (one for each hole). Secure 

the hood to the wall using 2 no. 8 x 3/4” screws and 

2 washers.

HD0380A

Ø 

 

4.  Position the blower on the higher (A) or lower (B) back wall 

discharge as determined previously.

  Using a 5/16” socket, or a Robertson or a Phillips no. 2 

screwdriver and the 4 previously removed screws, secure 

the blower to the hood.

 NOTE
  In order to ease installation, before mounting the blower, 

prepare the screw holes by screwing all 4 screws without 

the blower, then remove and mount the blower.

HD0387

5.  Plug the blower back in and plug hood power cord into the 

outlet.