Electrolux E15IM60E ユーザーズマニュアル
23
!
WARNING
WARNING
WARNING
WARNING
WARNING
Disconnect power to the ice maker before making any ice thickness adjustments.
Operation
ICE DISPENSER OPERATION & CARE
The ice cube thickness control is factory set for best overall performance. The
factory setting is designed to
maintain an ice bridge of
approximately 1/16" to 1/8" under
normal conditions resulting in a
dimple of approximately 1/4" to 1/2"
in depth (see Figure 28). A fuller
cube with less of a dimple results in
a thicker ice bridge. As the ice bridge
becomes thicker, the tendency for
the cubes to stay together as a slab
increases. A bridge thicker than 1/8"
may cause cubes to over-fill the ice
bucket.
factory setting is designed to
maintain an ice bridge of
approximately 1/16" to 1/8" under
normal conditions resulting in a
dimple of approximately 1/4" to 1/2"
in depth (see Figure 28). A fuller
cube with less of a dimple results in
a thicker ice bridge. As the ice bridge
becomes thicker, the tendency for
the cubes to stay together as a slab
increases. A bridge thicker than 1/8"
may cause cubes to over-fill the ice
bucket.
To adjust:
1
Disconnect power to the unit.
2
Remove the screws securing the
front access panel (see Figure 29).
front access panel (see Figure 29).
GOOD
BRIDGE
TOO THIN
BRIDGE
TOO THICK
DIMPLE
TOO DEEP
LITTLE OR
NO DIMPLE
1/4" TO 1/2"
DIMPLE
1/16" TO 1/8"
ICE BRIDGE
BAD
ICE002
Figure 28
Figure 29
ACCESS PANEL SCREWS