Sharp R-1482 ユーザーズマニュアル

21

OUTLINE OF TOUCH CONTROL PANEL

The power source synchronizing signal is available in
order to compose a basic standard time in the clock
circuit. It incorporates a very small error because it works
on commercial frequency.

A circuit to generate a signals which resetting the LSI to
the initial state when power is applied.

The buzzer responds to signals from the LSI to emit
audible sounds (key touch sound and completion sound).

A switch to inform the LSI if the door is open or closed.

To drive the magnetron, fan motor, stirrer motor, turnta-
ble motor, hood motor, and light the oven lamp and hood
lamp.

Indicator element is a Fluorescent Display.
Basically, a Fluorescent Display is a triode having a
cathode, a grid and an anode. Usually, the cathode of a
Fluorescent Display is directly heated and the filament
serves as cathode.
The Fluorescent Display has 8-digits, 15-segments are
used for displaying figures.

The touch control section consists of the following units
as shown in the touch control panel circuit.

(1) Key Unit
(2) Control Unit

The principal functions of these units and the signals com-
municated among them are explained below.

Key Unit
The key unit is composed of a matrix, signals generated in
the LSI are sent to the key unit through P00 - P07.
When a key pad is touched, a signal is completed through
the key unit and passed back to the LSI through R24 - R27
to perform the function that was requested.

Control Unit
Control unit consists of LSI, power source circuit, synchro-
nizing signal circuit, ACL circuit, buzzer circuit, relay circuit
and indicator circuit.

This LSI controls the key strobe signal, relay driving
signal for oven function and indicator signal.

This circuit generates voltages necessary for the control
unit from the AC line voltage.

Symbol

Voltage

Application

VC

-5.1V

LSI(IC1)

VP

-28V

Fluorescent display tube : Grid
and anode voltage

VF1-VF2

2.7Vac

Filament of fluorescent dis-
play tube
(VF1 to VF2 voltage)