Frigidaire FGMO205KW ユーザーズマニュアル
Specifications
subject to change.
FRIGIDAIRE®
USA
•
250 Bobby Jones Expressway
•
Martinez, GA 30907
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FGMO205K 05/09
© 2009 Electrolux Home Products, Inc.
Printed in the U.S.A.
Microwaves
FGMO205K F/ W/ B
Built-In
24
"
19
1
/
8
"
Power cord
location (right
top rear)
13
3
/
8
"
rear
extrusion
24" Built-In Microwave (2.0 cu.ft.)
with 27"or 30" Trim Kit
Professional and Gallery
Allow at least
21" clearance for door
depth when open
1"
30"or 27"
Trim Kit Faceplate
18"
(30") 30"
(27") 27"
120V/60Hz
grounded outlet
20" min.
4"
6"
4"
24
3
/
8
"min.
24
11
/
16
"max.
Bottom Duct Assembly
Outlet should NOT
be located within
shaded area UNLESS
cabinet depth is
greater than 21"
16
3
/
4
"min.
17"max.
*
Note: When used in combination with
another Frigidaire
®
built-in product, a
minimum clearance of 2
7
/
8
" required from
bottom of Built-In Microwave cutout to top
edge of companion product’s faceplate,
leaving a 2"visible gap between both
product faceplates
** Minimum cabinet width
required for installation
with optional 30" Trim Kit.
27" minimum cabinet width
27" minimum cabinet width
required for installation
with optional 27" Trim Kit.
30"min.**
20"
min.
Trim Kit –
7
/
8
" faceplate
overlap
16
3
/
4
"min.
17"max.
Full plywood
base required to
support 100 lbs.
24
3
/
8
"min.
24
11
/
16
"max.
2"
(visible
gap)*
Microwave Specifications
•
Product Shipping Weight (Approx.) – 46 Lbs. (not incl. Trim Kit)
•
Voltage Rating – 120V / 60 Hz / 15 or 20 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.7 kW
(For use on adequately wired 120V, dedicated circuit having
2-wire service with a separate ground wire. Appliance must
be grounded for safe operation.)
•
Amps @ 120 Volts = 14.3 Amps
•
Always consult local and national electric codes.
•
Microwave can stand alone on countertop or be built in with optional
30" or 27" Trim Kit (ordered by individual part number) which
includes Bottom Duct Assembly – shipped in separate box.
•
Allow 21" minimum clearance for 90° door swing.
•
Minimum 20" deep oven cutout dimension is critical for proper
installation for oven and faceplate to fit flush against cabinet front.
•
Consult local building code, in the event that cutout opening may be
required to be enclosed with sides, ceiling and rear partition.
•
Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
•
Base must be level and front of cabinet square for proper operation.
•
Grounded outlet should NOT be located in shaded area, as indicated,
UNLESS cabinet depth is greater than 21".
•
Can NOT be installed above any gas wall oven.
•
Built-In Microwave is approved to be used in combination with any
Frigidaire® Electric Single Wall Oven and /or Warmer Drawer. (Refer to
model-specific Combination Installation Specification pages on web.)
•
When used in combination with another Frigidaire® built-in product,
a minimum clearance of 2-7/8" required from bottom of Built-In
Microwave cutout to top edge of companion product’s faceplate,
leaving a 2" visible gap between both product faceplates.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions
Optional Accessories
•
30" Stainless Steel Trim Kit – (PN # MWTK30KF).
•
27" Stainless Steel Trim Kit – (PN # MWTK27KF).
•
30" White Trim Kit – (PN # MWTK30KW).
•
27" White Trim Kit – (PN # MWTK27KW).
•
30" Black Trim Kit – (PN # MWTK30KB).
•
27" Black Trim Kit – (PN # MWTK27KB).