Lincoln Series 1100 ユーザーズマニュアル

Impinger II – Digital Advantage Ops Manual –Dom & Int’l

CONVEYOR DISASSEMBLY FOR CLEANING

NOTE: The Conveyor Belt of the Impinger II and the Advantage oven does not have a tension adjustment.

If the belt would become too lose, a link will have to be removed to tighten. A belt that is too tight will also

cause operational problems due to excessive drag. We suggest that you may have a qualified service

technician perform this adjustment.

WARNING: Careful consideration should be exercised prior to removing a belt link because a belt that is

too tight will impede the smooth operation of the conveyor.

FINGER ASSEMBLY REMOVAL

DISASSEMBLY: The Connecting Links may be

removed with a pair of pliers by slipping the eye of

the connecting link over the wire of the other links.

Also notice the direction of the opening on the

other links. The belt will have to be reinstalled

with the opening facing the same way.

REASSEMBLY: Put conveyor belt back on by

setting the rolled belt to the idler end of the

conveyor and thread approximately 2/3 of the belt

over the bottom slider bed. Be sure belt is not

upside down. Reconnect conveyor belt by

slipping the connecting links back in place.

CAUTION:

OVEN MUST BE COOL

1. Open Door. NOTE: Door may be removed by lifting from hinges.