Zanussi ZEF 55 W ユーザーズマニュアル

Refit the upper hinge pin into the opposite location.
Fit the door in place on the hinge pin.
Slot the hinge pin into the hole in the hinge plate

and relocate the hinge assembly to the opposite

location and refit using the retaining screws.
Refit the bottom hinge plate assembly on the

opposite side, taking care that the edge of the door

is parallel with the side of the cabinet.

To reverse the handle proceed as follows:

Remove screw covers (if fitted) and handle retaining

screws. Remove blanking plugs on the opposite

side.
Relocate the handle to the opposite side and refit

retaining screws (covers if fitted), and replace the

blanking plugs.

Electrical Connection

Any electrical work required to install this

appliance should be carried out by a

qualified electrician or competent person.

This appliance must be earthed.
The manufacturer declines any liability should

these safety measures not be observed.

Electrical Requirements
Before switching on, make sure the electricity supply

voltage is the same as that indicated on the appliance

rating plate.
The appliance is supplied with a 13 amp plug fitted. In

the event of having to change the fuse in the plug

supplied, a 13 amp ASTA approved (BS 1362) fuse

must be used. Should the plug need to be replaced