Makita EH7500S ユーザーズマニュアル

DISASSEMBLING

(1) Disassemble the following parts from Engine.

          * Blower housing         * Muffler cover (out side)          * Muffler            * Cylinder cover

          * Plug cap                     * Spark plug                              * Ignition coil     * Carburetor

          * Clutch                        * Fly wheel

(2) Remove Fuel tank while paying attention not to lose Spacer which is fixed in between the Tank and Engine.

(3) Remove Insulator with Insulator gasket from Cylinder.

(4) Separate Cylinder from Crankcase assembly and remove Piston. (

)

1. Remove Piston clips from the both

    side of Piston with the awl.

    Note: Do not  reuse the removed 

              Piston clip. 

2. Remove Piston pin by pushing it 

    with 1R171.

    Now, Piston can be removed

    from Crankshaft.

ASSEMBLING

Cavity

(1) Before assembling Piston, apply one or two drops 2 stroke engine oil to Needle bearing on Crank shaft.

(2) Assemble Piston to Crank shaft. (Fig. 46)

Assemble Piston at the direction described below.

Cylinder

Crankcase

assembly 

Cylinder gasket

Awl

Piston clip

Piston clip

Crankshaft

Piston

Fly wheel

side

Piston

Piston pin

Piston pin

1R171

Fly wheel

side

Left

Right

P 23/ 25