Zenoah SRTZ2401 ユーザーズマニュアル
32
8. Operation
English
changing the angle of the blades, removing
branches which have become stuck in the blades,
or at any other time when coming into close
proximity with the blades.
branches which have become stuck in the blades,
or at any other time when coming into close
proximity with the blades.
• Always wear work gloves made of leather or some
other sturdy material when using the trimmer.
• Always place the blade cover provided with the
trimmer over the blades when not in use.
• Falling branches may fall onto the face or into
the eyes, resulting in injuries, scratches, and
cuts, and for this reason you should always be
sure to wear a helmet and face protector when
using your trimmer.
cuts, and for this reason you should always be
sure to wear a helmet and face protector when
using your trimmer.
• The thickness of branches which may be cut using
this trimmer is limited to up to approximately 3/16"
(4.8mm). Never try to cut branches thicker than this,
as doing so may result in damage to the trimmer.
(4.8mm). Never try to cut branches thicker than this,
as doing so may result in damage to the trimmer.
■ ADJUSTING THE ANGLE OF THE CUTTING
BLADES (OP7)
1. Stop the trimmer engine.
2. Turn the bolt located on the top of the trimming
2. Turn the bolt located on the top of the trimming
mechanism counter-clockwise to loosen it.
3. Adjust the angle of the blades to the desired angle,
and then fix the bolt firmly back into place.
(1) Clamp bolt
(2) Trimming mechanism
(3) Tighten
(4) Loosen
(2) Trimming mechanism
(3) Tighten
(4) Loosen
IMPORTANT
(1)
(2)
(3)
(4)
OP7