Ingersoll-Rand 651500-X プリント

209 NORTH MAIN STREET -BRYAN, OHIO 43506

 (800) 495-0276 

y

 FAX (800) 892-6276 

© 2011 

CCN 99711202

www.ingersollrandproducts.com

INCLUDE MANUALS: Form 772-2 Safety Precautions (pn 97999-540).

It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.

Use only genuine ARO® replacement parts to assure compat-

ible pressure rating and longest service life.

61240 for repair of spray gun.

The 651500-X control handle passes material at line pressure 
in a continuous flow. The hose connection is a 3/8” female 
pipe thread. The control handle will continue to pass material 
as long as the (15) lever is squeezed enough to lift the ball 
valve off  the valve seat.

For adjustments of the 651500-X control handle, the follow-
ing procedure will help.

To take slack out of the handle, adjust (8) set screw.
a.  Loosen (9) nut.
b.  Adjust (8) set screw to obtain desired play or slack.
c.  Tighten (9) nut.

2.  Should material leak from the lever end of the gun, re-

move the lever and tighten (11) retainer. If this does not 
stop the leak, remove the retainer and replace the (13) 
packings.

3.  Should you be unable to stop the fl ow of material from 

the extrusion gun, the (16) ball is probably not seating 
properly into the (3) ball seat. The ball should be removed 
and inspected for dirt or nicks. Also inspect the ball seat 
for dirt or nicks. If the ball or ball seat are damaged, they 
should be replaced. When pressing (3) insert and ball seat 
into place inside (18) body, make sure that the ball seat 
is facing in the proper direction. The material outlet of 
the insert must be in line with the outlet in the (18) body 
after being pressed into place.

1.