Patton electronic SN5200 ユーザーズマニュアル

Connecting the SmartNode to the Network

SmartNode 5200 User Manual 

Now you can set your IP address and network mask for the interface ETH 0/0 (WAN). Within this example a 
network 172.16.1.0/24 address is assumed. The IP address in this example is set to 172.16.1.99 (you should set 
this the IP address given to you by your network provider).

 

192.168.1.1(ctx-ip)[router]#interface eth0

 

192.168.1.1(if-ip)[eth0]#ipaddress 172.16.1.99 255.255.255.0

 

2002-10-29T00:09:40 : LOGINFO    : Link down on interface eth0.

 

2002-10-29T00:09:40 : LOGINFO    : Link up on interface eth0.

 

172.16.1.99(if-ip)[eth0]#

 

Copy this modified configuration to your new start-up configuration. This will store your changes in non-vol-
atile memory. Upon the next start-up the system will initialize itself using the modified configuration. 

 

172.16.1.99(if-ip)[eth0]#copy running-config startup-config

 

172.16.1.99(if-ip)[eth0]#

 

The SmartNode can now be connected to your network.

In general, the SmartNode will connect to the network via the WAN (ETH 0/0) port. This enables the Smart-
Node to offer routing services to the PC hosts on LAN (ETH 0/1) port. The SmartNode 5200 Series is 
equipped with Auto-MDX Ethernet ports, so you can use straight-through or crossover cables for host or 
hub/switch connections (see 

).

Figure 8. Connecting the SmartNode to the network

The interconnecting cables shall be acceptable for external use 
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and 
mechanical serviceability.

Straight-through wired or crossover cable

LAN (ETH 0/1)

LAN

WAN (ETH 0/0)

Network