Sharp R3.1 ユーザーズマニュアル

 

 

The following minimum hardware and software is required to use the Network Scanner Tool. 

•  Microsoft Windows 98, Millennium, NT 4.0 with SP6, 2000, and XP 
•  Internet Explorer 6.0 or above 
•  Pentium II 300 MHz or above 
•  64 MB RAM 
•  80 MB available hard disk space 
•  SVGA display 
•  TCP/IP networking installed (WinSock2 must be installed on all platforms) 
•  Ethernet card 
•  10Base or 100Base compatible Ethernet 

 

After installation, the Network Scanner Tool setup wizard automatically starts and scans your 
network to detect Sharp multifunction scanners. The configuration utility provides default 
destination identification and image-processing commands, which may be modified or 
expanded.  Once specified, these definitions are stored in your scanner’s Desktop Destination 
Profile web page. 
 

Profile Name 

A name that appears on the scanner’s front panel that refers to the rest of 

the settings in the destination profile. You typically select a profile by 

name before scanning a document. 

IP Address or 

Desktop Host 

Name 

This IP address or desktop host name is used to identify your computer 

that’s running the Network Scanner Tool. 

Desktop Port 

Number 

This number is used to contact the Network Scanner Tool on your 

computer. The default is 5133. If you change this number in the web page, 

be sure to also make the change in each computer’s Network Scanner 

Tool configuration that will receive scans from the scanner.  

Process Directory 

The Process Directory setting specifies the name of the currently selected 

Process Definition. Process Definitions that are defined in the Network 

Scanner Tool. For example, “Convert by OCR” tells the Network Scanner 

Tool to execute the “Convert by OCR” process when a scanned image 

arrives.  Refer to the Process Definition Tab discussion below for more 

information. 

 

Network Scanner Tool User’s Guide 

3