Canon M111021 ユーザーズマニュアル

Cleaning with the Cleaning Cards (U.S.A.
Only)

If a black stripe appears on the back-side of scanned images or if dirt
appears on the paper documents upon scanning or for preventative
measures, we recommend that you clean your Canon CR-Series
scanner as needed with a cleaning card. Using a cleaning card will
minimize the frequent cleaning as instructed in this manual.

It is best to perform a cleaning at beginning or end of the day. A
cleaning card does not clean the ink jet nozzles, so please remove the
ink cartridge and perform a nozzle cleaning (See “Cleaning the Ink Jet
Nozzles” on p. 19.)

IMPORTANT

• This operation is for U.S.A. Cleaning cards are available only in

U.S.A.

• Contact your local authorized Canon dealer or service

representative for the available cleaning card.

Turn OFF the scanner.

Disconnect the scanner and the computer.

Turn ON the scanner with pressing the START Button and
the STOP Button.

NOTE

If the scanner turned ON properly, the power LED continues to flash.

Pull the Eject Stopper.

Place the cleaning card in the document tray.

Press the START Button to start cleaning.

Please repeat steps 5 and 6.

A typical cleaning is feeding the cleaning card 3 to 7 times. If the
scanner is extremely dirty, you may need to use another cleaning
card.

Turn OFF the scanner.

Connect the scanner and the computer.

NOTE

• You cannot scan the document without the computer.
• Allow 1 to 2 minutes for the moisture on the Canon CR-Series

scanner from the cleaning card to thoroughly dry before scanning
documents.