Uniden UBCT9 ユーザーズマニュアル

SCAN

SCAN

If you enter a frequency which has been stored in another channel, you will hear an error
tone and the other channel displays.

Press   

  (decimal key) to clear and start again.

––– OR –––

Note:  Press E  again to store the frequency in both channels. The smallest channel  

  

 

  appears on the display when you store same frequency in two or more channels.

To avoid the accidental programming frequencies and talk group IDs, you can lock the
memory with Memory Lock.

Press and hold PROG for 2 seconds to activate this feature ,and “PROG” appears on
the display. If you press E to program memory, you will hear two beeps. To deactivate
Memory Lock, press and hold PROG for 2 seconds again.

1.   After programming frequencies, simply press 
 

HOLD/RESUME to begin scanning. Or pressing 

 

SCAN repeatedly until “SCAN”  appears on the

 

display, you can start Private Bank Scanning.

 

The scanner scans only upward all the channels.

2.   The bank indicators selected for scanning appear on the display, and the bank being
 

currently monitored flashes. You can deselect banks from active scanning by entering

 

their numbers on your keypad. The indicator for each deselected bank disappears, and

 

the bank’s channels are not scanned.

Note:  One bank must always be active. You cannot deactivate all five banks at the 
 

  same time. If you try to deselect all the banks, the first bank is automatically  

 

 

  selected. To restore a bank to active scanning, enter the bank’s number on your  

  

 

  keypad. The bank’s indicator will display again.

3.   During normal scanning the scanner skips
 

unprogrammed or locked out channels.

4.   When a transmission is received, the scanner stops
 

on that channel. When the transmission ends,

 

scanning resumes automatically.

Note:  You can set the scanner to hold for two seconds
 

  on the frequency for a response. For more

 

  information on Delay feature, please see page 28.

UBCT9 OM   22

12/11/07   3:53:40 PM