Intel SR1680MV ユーザーズマニュアル

xi

Warnings

Heed safety instructions: Before working with your server product, whether you are 

using this guide or any other resource as a reference, pay close attention to the safety 

instructions. You must adhere to the assembly instructions in this guide to ensure and 

maintain compliance with existing product certifications and approvals. Use only the 

described, regulated components specified in this guide. Use of other products / 

components will void the UL listing and other regulatory approvals of the product and 

will most likely result in noncompliance with product regulations in the region(s) in which 

the product is sold.

System power on/off: The power button DOES NOT turn off the system AC power. To 

remove power from system, you must unplug the AC power cord from the wall outlet. 

Make sure the AC power cord is unplugged before you open the chassis, add, or remove 

any components.

Hazardous conditions, devices and cables: Hazardous electrical conditions may be 

present on power, telephone, and communication cables. Turn off the server and 

disconnect the power cord, telecommunications systems, networks, and modems attached 

to the server before opening it. Otherwise, personal injury or equipment damage can 

result.

Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives, 

boards, and other parts. We recommend that you perform all procedures in this chapter 

only at an ESD workstation. If one is not available, provide some ESD protection by 

wearing an antistatic wrist strap attached to chassis ground any unpainted metal surface on 

your server when handling parts.

ESD and handling boards: Always handle boards carefully. They can be extremely 

sensitive to ESD. Hold boards only by their edges. After removing a board from its 

protective wrapper or from the server, place the board component side up on a grounded, 

static free surface. Use a conductive foam pad if available but not the board wrapper. Do 

not slide board over any surface.

Installing or removing jumpers: A jumper is a small plastic encased conductor that slips 

over two jumper pins. Some jumpers have a small tab on top that you can grip with your 

fingertips or with a pair of fine needle nosed pliers. If your jumpers do not have such a tab, 

take care when using needle nosed pliers to remove or install a jumper; grip the narrow 

sides of the jumper with the pliers, never the wide sides. Gripping the wide sides can 

damage the contacts inside the jumper, causing intermittent problems with the function 

controlled by that jumper. Take care to grip with, but not squeeze, the pliers or other tool 

you use to remove a jumper, or you may bend or break the pins on the board.