Intel SR1680MV ユーザーズマニュアル

163

Rack Mount Installation Guidelines 

Anchor the equipment rack:  The equipment rack must be anchored to an unmovable 

support to prevent it from falling over when one or more servers are extended in front of 

the rack on slides. You must also consider the weight of any other device installed in the 

rack. A crush hazard exists should the rack tilt forward which could cause serious injury.

Temperature:  The temperature, in which the server operates when installed in an 

equipment rack, must not go below 5 °C (41 °F) or rise above 40 °C (104 °F). Extreme 

fluctuations in temperature can cause a variety of problems in your server.

Ventilation:  The equipment rack must provide sufficient airflow to the front of the server 

to maintain proper cooling. The rack must also include ventilation sufficient to exhaust a 

maximum of 1023 BTU's (British Thermal Units) per hour for the server. The rack 

selected and the ventilation provided must be suitable to the environment in which the 

server will be used.

Mains AC power disconnection:  The AC power cord(s) is considered the mains 

disconnect for the server and must be readily accessible when installed. If the individual 

server power cord(s) will not be readily accessible for disconnection then you are 

responsible for installing an AC power disconnect for the entire rack unit. This main 

disconnect must be readily accessible, and it must be labeled as controlling power to the 

entire rack, not just to the server(s).  

Grounding the rack installation:  To avoid the potential for an electrical shock hazard, you 

must include a third wire safety ground conductor with the rack installation. If the server 

power cord is plugged into an AC outlet that is part of the rack, then you must provide 

proper grounding for the rack itself. If the server power cord is plugged into a wall AC 

outlet, the safety ground conductor in the power cord provides proper grounding only for 

the server. You must provide additional, proper grounding for the rack and other devices 

installed in it. 

Standard icon for 
Power button

Should be attached on power button

Table 48. Product Regulatory Compliance Markings

Regulatory Compliance

Country

Marking