Lenovo 3821 ユーザーズマニュアル
Installing a 2.5-inch disk drive backplane
1
Latch
2
Tabs
3
Configuration cable connector
4
SAS signal cable connector
5
2.5-inch hot-swap backplane
6
Power cable connector
7
Locator pin
To install a 2.5-inch hard disk drive backplane, complete the following steps:
1. Touch the static-protective package that contains the hard disk drive backplane
to any unpainted metal surface on the server; then, remove the backplane
from the package.
from the package.
2. Position the 2.5-inch hard disk drive backplane in the drive-cage retention tabs;
then, rotate the top of the backplane toward the locator pins until the latch
clicks into place
clicks into place
3. Connect the power, signal, and configuration cables to the 2.5-inch hard disk
drive backplane (see “2.5-inch hard disk drive backplane connectors” on page
147 and “Internal cable routing and connectors” on page 163).
147 and “Internal cable routing and connectors” on page 163).
4. If you are replacing another 2.5-inch hard disk drive backplane, repeat steps 1
through 3 to install the additional backplane.
5. Install the hot-swap hard disk drives (see “Installing a 2.5-inch hot-swap hard
6. Close the bezel (see “Closing the bezel” on page 151).
7. Install the fan-cage assembly (see “Installing the fan-cage assembly” on page
8. Install the air baffle (see “Installing the air baffle” on page 170).
9. Return the power-supply cage to its closed position (see “Closing the
200
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual