Fujitsu LT800P ユーザーズマニュアル

IP packet isn’t 
reaching its 
destination

Run the PING 
command to check 
the connection

Perform the following steps to run the 
PING command to check if the IP packet is 
correctly delivered to the destination.

To run the PING command, the TCP/IP 
protocol must be installed. First you will 
determine your IP address, then you will 
make sure your IP address can respond, 
and then you will make sure other 
computers can be addressed. 

1.    Windows 2000: 

Click [Start] -> [Programs] -> [Acces-
sories] -> [Command Prompt].
Windows XP: 
Click [Start] -> [All Programs] -> 
[Accessories] -> [Command Prompt].

2.   Type: ipconfig > directory\filename
      where directory and filename repre-

sent the location at which you want to 
store the IP address.

3.   Click [Enter], then go to the location 

you specified above. The IP address 
for your system will be contained in 
the file.

4.   To check that your IP address is func-

tioning properly, go back to the DOS 
prompt and type: ping <IP address>, 
then press [Enter]. You will receive 
several replies, followed by the PING 
statistics (similar to below).

5.   To check that your system is communi-

cating with other systems, go to the 
DOS prompt and type:
\>ping XXX.XXX.XXX.XXX. (With the 
destination IP address in place of 
XXX.XXX.XXX.XXX).

(continued on next page)

58-0867-01.book  Page 90  Thursday, February 13, 2003  1:18 PM