HP (Hewlett-Packard) 9000 V2600 SCA ユーザーズマニュアル

SSP operation

prompting the user if only one complex is configured). This utility 
accesses the desired node based on node ID. However, the single node 
must still be configured by 

ts_config

 and assigned a complex name 

before it can be accessed.

Use the 

jf-ccmd_info

 command to determine what names or IP 

addresses the JTAG interfaces have been set to on an SPP. The command 
provides a list with the following information:

• Ethernet Address (MAC)

• IP  Address

• Complex Serial Number

• Node Number

• Environmental LED’s

• Power Status

• SCUB Status

• Diagnostic (JTAG) node names

The diagnostic node name or the JTAG IP address is required when 
using the 

load_eprom

 command. Since the SSP software allows 

changing the default JTAG hostnames and IP addresses, the user may 
need to run this command to view the unique names and active IP 
addresses for JTAG.

Example: