Sony 8000SF ユーザーズマニュアル
198
Setup
Cha
• Source/Dest Name: For the Source/Dest (source/destination) names used by
the system, select one of the following:
– Source name set by cross-point assignment or fixed bus name
– Description name set on routing switcher
– “Type + Num” name set on routing switcher
Names assigned with Xpt Assign can be replaced later with description
names.
– Source name set by cross-point assignment or fixed bus name
– Description name set on routing switcher
– “Type + Num” name set on routing switcher
Names assigned with Xpt Assign can be replaced later with description
names.
• Name Display: Specify the number of characters for display of the names
selected in Source/Dest Name above, as two characters, four characters, or
Auto.
Auto.
• Flexi Pad: Carry out Flexi Pad settings. Specify the delegation selection
coupling, and display mode for the LCD buttons. You can also make menu
settings for wipe snapshots.
settings for wipe snapshots.
• Custom Button: Set the following button operation modes.
– [ALL] button for next transition selection
– [AUTO TRANS], [TAKE] or [FTB] button during auto transition
– [AUTO TRANS], [TAKE] or [FTB] button during auto transition
execution
– [RUN] button during keyframe execution
– [AUTO TRANS] and [CUT] button replacement
– [TRANS PVW] button
– [UTIL] button
– [XPT HOLD] button in key rows
– Selection of signal assigned to the auxiliary bus control block key source
– [AUTO TRANS] and [CUT] button replacement
– [TRANS PVW] button
– [UTIL] button
– [XPT HOLD] button in key rows
– Selection of signal assigned to the auxiliary bus control block key source
bus (either key signal only, or either video signal or key signal selectable)
• Sensitivity: Adjust trackball, joystick and double-click sensitivity, or set the
relationship between the angle of the search dial and the playback speed.
• Main Split Fader: When the split fader is active, specify whether the fader
to control other than mix is the left side or the right side.
• Macro: Set the macro execution mode and the mode in which to edit macros
using the standard type Flexi Pad control block.
Screen saver and other settings (Maintenance)
• Screen Saver: Make the menu screen saver settings.
• LCD Brightness: Adjust the LCD brightness.
• LED Brightness: Adjust the LED brightness.
• Switch Brightness: Adjust the switch brightness.
• Touch Beep: Select whether or not to sound a beep when a menu operation
• LCD Brightness: Adjust the LCD brightness.
• LED Brightness: Adjust the LED brightness.
• Switch Brightness: Adjust the switch brightness.
• Touch Beep: Select whether or not to sound a beep when a menu operation
is carried out.
• Touch Panel Calibration: Calibrate the touch panel.
• Initial Menu Set: Specify the menu to be displayed at menu startup.
• Initial Menu Set: Specify the menu to be displayed at menu startup.
Switcher Setup
In switcher setup, make settings particular to the switcher processor.