3com 3C16790 ユーザーズマニュアル
15
P
ROBLEM
S
OLVING
The Switch has been designed to aid you when detecting
and solving possible problems with your network. These
problems are rarely serious; the cause is usually a
disconnected or damaged cable, or incorrect configuration.
If this section does not solve your problem, contact your
supplier for information on what to do next.
and solving possible problems with your network. These
problems are rarely serious; the cause is usually a
disconnected or damaged cable, or incorrect configuration.
If this section does not solve your problem, contact your
supplier for information on what to do next.
Perform these actions first:
■
Ensure all network equipment is powered on.
■
Power each piece of network equipment off, wait about
5 seconds and then power each one on.
5 seconds and then power each one on.
Check the following symptoms and solutions:
Power LED not lit. Check your power adapter connection.
If there is still no power, you may have a faulty power
adapter which needs replacing with another OfficeConnect
power adapter. Do not use any other power adapter
with the Switch.
If there is still no power, you may have a faulty power
adapter which needs replacing with another OfficeConnect
power adapter. Do not use any other power adapter
with the Switch.
Port Status LED not lit for a port that has a TP cable
connected. After connection it may take several seconds
for the port status LED's to illuminate. The port status LED
should turn Green or Yellow for each port that is
connected. The Duplex LED may or may not illuminate.
connected. After connection it may take several seconds
for the port status LED's to illuminate. The port status LED
should turn Green or Yellow for each port that is
connected. The Duplex LED may or may not illuminate.
Please refer to pages 5 and 6 'Creating your Network' for a
full description of the LED's.
full description of the LED's.
lf the Port Status LED has not lit after several seconds
ensure the connected device is powered, the TP cable is not
damaged and that it is correctly inserted at both ends.
ensure the connected device is powered, the TP cable is not
damaged and that it is correctly inserted at both ends.
You may find a TP cable works when connected to the
Switch but doesn't if it is disconnected from the Switch and
connected to a different piece of equipment. This may be
due to the advanced automatic MDI / MDIX feature of the
Switch that the other equipment may not have.
Switch but doesn't if it is disconnected from the Switch and
connected to a different piece of equipment. This may be
due to the advanced automatic MDI / MDIX feature of the
Switch that the other equipment may not have.
Alert LED continuously lit. If the Alert LED is lit, there is a
problem with the network. Remove the port connections
one at a time, waiting a few seconds between each port. If
the Alert LED goes off, there is either a network loop or an
excessive amount of broadcast traffic on that port
connection:
problem with the network. Remove the port connections
one at a time, waiting a few seconds between each port. If
the Alert LED goes off, there is either a network loop or an
excessive amount of broadcast traffic on that port
connection:
Network loop — Examine your connections and remove the
loop. Each piece of equipment needs only one connection
to your Switch.
loop. Each piece of equipment needs only one connection
to your Switch.
Excessive amounts of broadcast frames — Some pieces of
network equipment operate by sending out broadcast
network equipment operate by sending out broadcast
3C16734_Booklet.book Page 15 Monday, March 12, 2001 1:46 PM