3com TR ユーザーズマニュアル

C

HAPTER

 3: S

ETTING

 U

P

 

FOR

 M

ANAGEMENT

Press [Enter].

A blank decimal notation appears in the Default 
Router field.

Enter the Default Router address as follows: 

■

Select the value of the digit by moving the 
[Up or Down Arrow] until the desired value 
appears. Choose from 0 through 9 and “.”.

■

Select the desired digit by moving the [Right 
Arrow].

Press [Enter] to accept the address.

Press [Left Arrow] to return to the higher level screens 
in the LCD console. 

You are now ready to communicate with the Switch 
2000 TR using IP and an SNMP-based management 
application. Refer to Chapter 5 for more information 
on configuring the bridge, port, and other manage-
ment tasks.

The BOOTP option allows you to enable or disable the 
bootstrap protocol. The BOOTP (bootstrap protocol) 
allows the switch to discover and learn its own IP 
address and routing table information. To configure a 
Switch 2000 TR with the BOOTP option you will need 
a BOOTP server program. The MAC address, recorded 
on a label on the rear panel of the Switch 2000 TR, 
must be entered in the BOOTP server program along 
with the corresponding IP address of the Switch 2000 
TR and its default route information. This allows the 
BOOTP request from the agent to be logged by the 
BOOTP server which then supplies the required IP 
information. 

Follow the instructions below to set the BootP com-
munications parameters.

Log on to the Switch 2000 TR.

Select Switch Management from the main menu.

Select *Stack*

Select Setup.

The Stack Setup screen appears. See Figure 3-12.

Enabled
(default)

No

Sent continuously (approx. 
every 512 secs.) until 
address is discovered

Enabled

Yes

Not sent, IP address is 
known

Disabled

Yes/No

Not sent