HP (Hewlett-Packard) BMD00022 ユーザーズマニュアル

Configuration Menu 144

Table 111

CIST Port Configuration Menu options

Command Description

edge disable|enable

Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the link

is up. Configure server ports as edge ports (enabled). This command is
disabled by default.

Enables CIST on the port.

off

Disables CIST on the port.

cur

Displays the current CIST port configuration.

Spanning Tree configuration

Command: /cfg/l2/stp <1-128>

[Spanning Tree Group 1 Menu]

brg - Bridge parameter menu

port - Port parameter menu

add - Add VLAN(s) to Spanning Tree Group

remove - Remove VLAN(s) from Spanning Tree Group

clear - Remove all VLANs from Spanning Tree Group

on - Globally turn Spanning Tree ON

off - Globally turn Spanning Tree OFF

default - Default Spanning Tree and Member parameters

cur - Display current bridge parameters

The HP 10GbE switch supports the IEEE 802.1D Spanning Tree Protocol (STP) and Cisco proprietary

PVST and PVST+ protocols. You can configure up to 127 spanning tree groups on the switch (STG
128 is reserved for switch management). Spanning Tree is turned on by default.

NOTE:

When RSTP is turned on, only STP group 1 can be configured.

The following table describes the Spanning Tree Configuration Menu options.

Table 112

Spanning Tree Configuration Menu options

Command Description

brg

Displays the Bridge Spanning Tree Menu.

port <port number>

Displays the Spanning Tree Port Menu.

add <1-4094>

Associates a VLAN with a spanning tree and requires an external VLAN ID as a

parameter.

remove <1-4094>

Breaks the association between a VLAN and a spanning tree and requires an
external VLAN ID as a parameter.

clear

Removes all VLANs from a spanning tree.

Globally enables Spanning Tree Protocol.

off

Globally disables Spanning Tree Protocol.

default

Restores a spanning tree instance to its default configuration.