Q-Logic 16-Feb ユーザーズマニュアル

B – Command Line Interface
Set Setup Command

B-44

59021-06 A

D

system
Prompts you in a line-by-line fashion to change system configuration settings. 

 describes the system configuration fields. For each parameter, enter a 

new value or press the Enter key to accept the current value shown in brackets.

TrapCommunity

Trap community password that authorizes an SNMP agent 
to receive traps. This is a write-only field. The value on the 
switch and the SNMP management server must be the 
same. The default is “public”.

AuthFailureTrap

Enables (True) or disables (False) the generation of traps in

response to trap authentication failures. The default is False.

ProxyEnabled

Enables (True) or disables (False) SNMP communication 
with other switches in the fabric. The default is True.

Changing the IP address will terminate all Ethernet management 
sessions.

Eth0NetworkDiscovery

Ethernet boot method: 1 - Static, 2 - Bootp, 3 - 
DHCP, 4 - RARP. The default is 1 - Static.

Eth0NetworkAddress

Ethernet Internet Protocol (IP) address. The 
default is 10.0.0.1.

Eth0NetworkMask

Ethernet subnet mask address.

Eth0GatewayAddress

Ethernet IP address gateway.

FCNetworkDiscovery

Fibre Channel boot method: 1 - Static,  3 - DHCP. 
The default is 1 - Static.

FCNetworkAddress

Fibre Channel Internet Protocol (IP) address for 
the Ethernet port. The default is 0.0.0.0.

FCNetworkMask

Fibre Channel subnet mask address. The default is 
255.0.0.0.

FCGatewayAddress

Fibre Channel IP address gateway. The default is 
10.0.0.254.