Mitsubishi Electronics XL21 ユーザーズマニュアル
REV 2.4
29
1.4.3.2. 6-axis
adjustment
1.4.3.2.1. Release the lock screws
Before 6-axis adjustment, release locks
in the adjuster. Loosen 4 locking screws
with an Allen wrench (2mm) and 5 fixing
screws with an Allen wrench (4mm).
in the adjuster. Loosen 4 locking screws
with an Allen wrench (2mm) and 5 fixing
screws with an Allen wrench (4mm).
1.4.3.2.2. When adjusting with motorized adjustment tool, S-AXL50E
Attaching
1. Set the rotary dial in the upper unit
1. Set the rotary dial in the upper unit
of the adjustment tool according to
the product (chapter 3.8.4.2, on
page 97). The initial setting is 0.
the product (chapter 3.8.4.2, on
page 97). The initial setting is 0.
•
F
F
r
r
o
o
n
n
t
t
: Set it 0.
•
R
R
e
e
a
a
r
r
: Set it 1.
2. Make sure the slide switch is set
OPE (right side).
3. Connect the upper and lower units with a supplied
unit-connecting cable.
4.
Connect a supplied cube-connecting cable with upper
unit.
unit.
5. Open the screen (chapter 1.2.7.1, on page 21) or rear
panel to access the 6-axis adjuster.
Note:
For
Note:
For
R
R
e
e
a
a
r
r
, open the rear panel 180 degrees or
remove it to perform the adjustment. Adjustment with
half-open panel may cause breakage due to
interference with the adjustment tool.
half-open panel may cause breakage due to
interference with the adjustment tool.
Unit-connecting cable
Cube-connecting cable
Upper unit
Lower unit
Slide switch
Rotary Dial
OPE
RESET
POWER
0 : FRONT
1 : REAR
9 : TEST
1 : REAR
9 : TEST
FACTORY
ERROR
FW-EN
5 fixing screws
4 locking screws
Rear panel