HP (Hewlett-Packard) 651176-002 ユーザーズマニュアル
Troubleshooting 60
Checksum failure error
A Checksum failure error occurs when executing a bad load sequence, or having an incorrect EEPROM map
while loading software through the serial or USB port.
Action:
while loading software through the serial or USB port.
Action:
1.
Rerun the firmware upgrade.
2.
If the condition persists, contact an HP authorized service representative.
UPS does not start
Action:
1.
Be sure that the power cord is plugged in to a utility power receptacle.
2.
Check the power source at the utility power receptacle.
Low battery shutdowns
Ungraceful shutdown of attached servers occurs when the UPS is in a low battery condition.
Action:
Action:
1.
Verify that the power management software is not delaying the shutdown of attached servers when the
UPS is in a low battery condition.
UPS is in a low battery condition.
2.
Allow the UPS batteries to charge for 24 hours.
3.
If the Battery Fault LED is red, replace the batteries ("
" on page
UPS does not provide the expected backup time
Action:
1.
If the Overload LED ("
" on page
) is illuminated, remove one or more load
devices to reduce the power requirements.
2.
Power down the UPS ("
" on page
3.
Allow the UPS batteries to charge for 24 hours.
4.
Initiate a self-test ("
" on page
5.
During extended power outages, save your work, power down the load devices, and then power down
the UPS ("
the UPS ("
" on page
) to conserve battery power.
UPS frequently switches between utility and battery
power
power
Action:
1.
Check the input voltage and reconfigure the UPS ("
" on page
2.
Contact a qualified electrician to verify that the utility power is suitable for the UPS.