Marantz VP8600 ユーザーズマニュアル
4
ENGLISH
Rear and Terminals View
z
v
b
n
m
,
.
⁄0
⁄1
⁄2
x
c
z S-VIDEO IN
Connect an S-video enabled device.
x VIDEO IN
Connect a composite video enabled device.
c COMPONENT VIDEO IN 1
Connect a component video enabled device.
v COMPONENT VIDEO IN 2
Connect a component video enabled device.
b RGB IN
Connect to a computer.
n DVI-D IN
Connect a DVI (digital) cable from a computer
or video source.
or video source.
m RS-232C
This is a service port for firmware upgrades.
, TRIGGER 1
Connect to the screen.
When the unit is turned on, 12V is output.
When the unit is turned off, no voltage is
output. This allows such as a powered
up/down screen,whenever the projector is
turned on or off.
When the unit is turned on, 12V is output.
When the unit is turned off, no voltage is
output. This allows such as a powered
up/down screen,whenever the projector is
turned on or off.
Note:
To connect with external devices, use
an ordinal 3.5mm mini-plug (mono)
cable.
an ordinal 3.5mm mini-plug (mono)
cable.
. TRIGGER 2
Connect to the screen to control screen
aspect ratio with powered up/down dual
aspect ratio screen. If Normal (4:3) aspect
ratio is selected by projector, 12V is output.
aspect ratio with powered up/down dual
aspect ratio screen. If Normal (4:3) aspect
ratio is selected by projector, 12V is output.
Notes:
•
Do not use TRIGGER 1 and TRIGGER
2, as the power source.
2, as the power source.
•
To connect with external devices, use
an ordinal 3.5mm mini-plug (mono)
cable.
an ordinal 3.5mm mini-plug (mono)
cable.
⁄0 IR receiver
Rear receiver for IR signal from remote
control.
control.
⁄1 Main power switch
Turns the main power to the unit on or off.
⁄2 AC IN socket
Connect to an electrical outlet.
Note:
•
If your video equipment has both S-
video and RCA jacks (composite video)
connect to the S-video connector.
S-video provides a better quality signal.
video and RCA jacks (composite video)
connect to the S-video connector.
S-video provides a better quality signal.
VP8600_eng 05.10.25 9:33 AM ページ4