Marantz VP8100 ユーザーズマニュアル
4
INTRODUCTION
ENGLISH
z COMPONENT VIDEO IN
Y, P
B
/C
B
, P
R
/C
R
connectors.
Connect to the COMPONENT VIDEO output of video
equipment or an A/V processor/receiver with a component
video loop.
equipment or an A/V processor/receiver with a component
video loop.
x S-VIDEO IN
Connect to the S-VIDEO output of a video equipment.
c VIDEO IN
Connect to the composite video output of a video equipment.
v RGB IN
Connect to the analog RGB output of a computer equipment.
b REMOTE SW. (EXTERNAL/INTERNAL)
When using the MARANTZ REMOTE CONTROL system, select
EXTERNAL. Otherwise select INTERNAL.
EXTERNAL. Otherwise select INTERNAL.
n REMOTE CONTROL IN/OUT
Connect to the REMOTE CONTROL connectors of other
Marantz equipment. It is then possible to control the whole
system with a single Remote Controller.
Marantz equipment. It is then possible to control the whole
system with a single Remote Controller.
m TRIG.1 OUT
When the projector is turned on, a 12-volt signal is sent to the
equipment connected to the TRIG.1 OUT. This allows
automatic triggering of an accessory, such as a powered
up/down screen, whenever the projector is turned on or off.
When the unit is turned off, no voltage is output and when the
unit is turned on, 12 V is output.
equipment connected to the TRIG.1 OUT. This allows
automatic triggering of an accessory, such as a powered
up/down screen, whenever the projector is turned on or off.
When the unit is turned off, no voltage is output and when the
unit is turned on, 12 V is output.
Note:
You cannot use the connector as the power source.
You cannot use the connector as the power source.
, TRIG.2 OUT
Either A 12-volt signal or a 0-volt signal is sent to the
equipment connected to the TRIG.2 OUT, according to the
setting in the OSD menu.
equipment connected to the TRIG.2 OUT, according to the
setting in the OSD menu.
Note:
This cannot be used for these connectors, TRIG.1 OUT and
TRIG.2 OUT, as the power source.
This cannot be used for these connectors, TRIG.1 OUT and
TRIG.2 OUT, as the power source.
. Adjuster button
When using adjuster, press the button and loosen an adjuster.
⁄0 Adjuster
⁄1 Rear adjuster
Adjust the vertical angle of the projector.
⁄2 Ventilation holes
⁄3 IR sensor
⁄4 AC IN
Connect the supplied AC power cord.
EXT. INT.
OUT
TRIG.2
REMOTE CONTROL
TRIG.1
RGB IN
Y
P
B
/C
B
COMPONENT VIDEO IN
S-VIDEO
IN
VIDEO IN
P
R
/C
R
IN
n
b
c
⁄0
⁄3
⁄2
m , v
z
x
⁄4
⁄1
⁄2
⁄0
⁄0
.
Connector panel and Rear