HP (Hewlett-Packard) A6584A ユーザーズマニュアル
Installing the HP UPS Power Protection Agent 39
3.
From the directory that contains all five files, run
./SetupRA -s -f DevManRA.ini
to install
silently.
If the .ini file is not located in the same folder as the SetuprRA file, run
If the .ini file is not located in the same folder as the SetuprRA file, run
./SetupRA -s -f
<path> DevManRA.ini,
where <path> is the
DevManRA.ini
file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
Parameter Function
-s
Performs a silent install.
-l
Creates an installation log
(opt/DevMan/install.log). Default is disabled for
(opt/DevMan/install.log). Default is disabled for
interactive mode and enabled for silent mode. The
installation log is created automatically for
Windows® during silent installations in
\%systemdrive%\setup.log.
\%systemdrive%\setup.log.
-f DevManRA.ini
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
installs. When this option is specified, the device
detection and configuration step is omitted.
Reconfiguring the agent on HP-UX operating systems
To reconfigure the management module IP address or serial path, run
/sbin/init.d/DevMan setup
.
Uninstalling components from Windows® systems
1.
Click Start>Settings>Control Panel.
2.
Open Add/Remove Programs.
3.
Select UPS Power Protection Agent, and then click Change/Remove.
The uninstall wizard launches.
Select Remove Choice, and then click Next.
The uninstall wizard launches.
Select Remove Choice, and then click Next.
4.
Follow the prompts in the uninstall wizard to uninstall the software.
NOTE:
Some files might remain following the uninstallation and can be removed manually.
Uninstalling components from Linux systems
Execute the uninstall script (
./Uninstall
).
NOTE:
Some files might remain following the uninstallation and can be removed manually.
Uninstalling components from HP-UX systems
Execute the uninstall script (
./Uninstall
).